Quantum Data 802R Guide de l'utilisateur télécharger pdf (Page 196)

100

101

186 Chapter 11 Testing HDCP

Testing DVI or HDMI receiver with HDCP

This section describes how to test DVI and HDMI receivers with HDCP.

All DVI and HDMI options, including analyzer options, support HDCP production keys if

the HDCP option is installed. Some DVI options support both production and public keys.

To determine which HDCP keys your generator supports:

1. Load the GenStats image.

2. Verify that HDCP is listed under the Options heading, which indicates that the HDCP

option is installed, and that production keys are available.

3. If the following image names are listed on the LCD, then HDCP public (test) keys are

installed.

• HdcpA1B1

• HdcpA1B2

• HdcpA2B1

• HdcpA2B2

Note: With older firmware installed, you may be able to select these images, but an

“Image is not available” message is displayed on the display connected with the

generator. This message indicates that public keys are not installed.

To test HDCP with a DVI device:

1. Hold down the G and B key while starting the generator put the generator in digital

friendly mode.

Alternatively, enter the following command:

SROP 2

2. Connect the DVI transmitter on the generator to the device’s DVI receiver.

3. Select an appropriate HDCP test image.

If you are testing a device with a production key, select the HdcpProd(uction) image.

The HdcpProd image assumes that both the HDCP transmitter and receiver have a

production key.

If your generator supports public keys, select the appropriate image below. For

example, if the receiver has pubic key B2, and you want to use public key A1 in the

transmitter, then select the HdcpA1B2 image.

• HdcpA1B1

• HdcpA1B2

• HdcpA2B1

1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 743 744

Commentaires sur ces manuels

Pas de commentaire

Quantum Data 802R Guide de l'utilisateur Page 196

Commentaires sur ces manuels

Produits connexes et manuels pour Générateurs d'électricité Quantum Data 802R