Quantum Data 802R Guide de l'utilisateur télécharger pdf (Page 141)

100

101

802BT/802R Video Test Generator User Guide 131

To view specific timing information of an external HDMI/DVI source signal:

1. Connect the HDMI/DVI transmit device to the HDMI/DVI Rx connector on the generator.

2. Using a terminal emulator, establish a terminal connection with the generator. Refer to

“Setting up a terminal connection with the generator” on page 14.

3. Enter the following commands to configure the generator to output a digital signal

(HDMI or DVI):

SROP 2 4

This removes analog friendly mode and configures the generator to output either a DVI

or HDMI signal depending on the interface hardware the generator is equipped with

(DVI or HDMI).

4. (optional) Enter the following command to set the status display mode:

SROP 8

5. Enter the following commands to initiate the measurement of timing parameters.

PNSF 1 // selects the source of timing information as “Measured”

TMAU // initiates measurement of timing from external source

HTOT? // queries for the horizontal total pixels

HRES? // queries for the horizontal active pixels

See page 548 for additional parameters you can query.

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 743 744

Commentaires sur ces manuels

Pas de commentaire

Quantum Data 802R Guide de l'utilisateur Page 141

Commentaires sur ces manuels

Produits connexes et manuels pour Générateurs d'électricité Quantum Data 802R