Quantum-data 801GC Manuel d'utilisateur télécharger pdf (Page 302)

6-176 Chapter 6: Programming

Model 801GC, 801GF & 801GX¥Rev. A

*WAI WAIt for completion suffix

Classification: Direct processor control

Command Syntax: <command>; *WAI

Limits: <command>

FMTU, IMGU, ALLU, BOOT, INIT, or SCAL

Query Syntax: None

Description: Normally, the generator returns a prompt immediately after either

an FMTU, IMGU, ALLU, BOOT, INIT, or SCAL command is

received - even before these commands have finished executing.

If the system controlling the generator must know when a

command has finished executing, use a semicolon to append

the suffix … ;*WAI. This causes the generator to wait until all

processes have been completed before sending the > prompt.

Other Required Cmds: The *WAI command is used as a suffix with the FMTU, IMGU,

ALLU, BOOT, INIT and SCAL commands.

Example: FMTL vga_m3 // Load a format from memory

// to buffer

IMGL SMPTE133 // Load the SMPTE RP-133

// image to buffer

ALLU;*WAI // Update hardware to current

// buffer contents and delay

// prompt until all done

XVSG Video Signal Gating

Classification: Format parameter setting

Command Syntax: XVSG <red mode>, <green mode>, <blue mode>

Limits: < mode>

0 = OFF

1 = ON

Description: The XVSG command determines which video outputs are active

when the format is selected. The same command controls both

the analog and digital video outputs.

Other Required Cmds: The FMTU command instructs the generator to use the new

setting. The ALLU command updates hardware to the new setting

and redraws the test image.

Example: XVSG 1 1 1 // Enable all color channels

FMTU // Update hardware to current

// buffer contents

1 2 ... 297 298 299 300 301 302 303 304 305 306 307 ... 355 356

Pas de commentaire

Quantum-data 801GC Manuel d'utilisateur Page 302