Quantum-data 801GC Manuel d'utilisateur télécharger pdf (Page 195)

100

101

6-69

Bus Commands

Bus commands - commands which are sent to the

801G* with ATN true - are defined in the IEEE-488.1

standard. The details of operation of these commands

are defined in the IEEE-488.1 and 488.2 standards.

The following bus commands are supported by the

801G*:

DCL Device Clear - Clears the input buffer and

output queue, and stops parsing any com-

mands.

SDC Selected Device Clear - Same as Device Clear.

GTL Go To Local - Enters the local state. See the

Remote/Local section.

LLO Local Lockout - Enters the lockout state. See

the Remote/Local section.

SPE Serial Poll Enable - Enables transmission of

the Status Byte.

SPD Serial Poll Disable - Exits the serial poll state.

Common Commands

The common commands used by the 801G* are listed

on the following pages. Common commands are com-

mands which begin with an asterisk (*). These com-

mands are defined by the IEEE-488.2 standard and

operate the same from instrument to instrument. The

801G* supports all required common commands plus

one additional command (*OPT?).

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 355 356

Commentaires sur ces manuels

Pas de commentaire

Quantum-data 801GC Manuel d'utilisateur Page 195

Commentaires sur ces manuels

Produits connexes et manuels pour Générateurs Quantum-data 801GC