Quantum-data 882E Manuel d'utilisateur télécharger pdf (Page 32)

31 882E Quick Start Guide - HDCP Compliance Testing with Encryption Status Tester (EST) - P/N 68-00210 Rev. B

1. Connect the cables as follows:

a. Apply power to the Encryption Status Tester (EST) using the power adapter

supplied with the EST.

b. Connect an HDMI cable from the repeater device under test input to the EST HDMI

port labeled, “HDMI OUT.”

c. Connect an HDMI cable from the 882 HDMI Rx 1 port to the HDMI output of the

repeater device under test.

d. Connect an HDMI cable from the 882 HDMI Tx 1 port to the EST HDMI port labeled

“HDMI IN.”

e. Connect an HDMI cable from the 882 HDMI Tx 2 port to the EST HDMI port labeled

“HDMI.”

The following diagram depicts the test setup for the 882EA:

2. Activate the HDMI-H interface on the output port as follows:

a. Press the Interface key. A listing of signal interfaces appears on the generator’s

display as shown below.

b. Choose the HDMI-H item by pressing the adjacent soft key. The interface is

activated and the display is shown below.

Alternatively, to activate the interface through the command line interface, enter the

following commands:

VGA

HDMI-D

CVBS

S-VIDEO

SDI

HDMI-H

VGA

HDMI-D

CVBS

S-VIDEO

SDI

*HDMI-H

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 47 48

Pas de commentaire

Quantum-data 882E Manuel d'utilisateur Page 32