
Model 801 Series Quick Start Guide • 5 •
Special Button Combinations
Image Outputs
STEP R G B ACS DCS DSS ON
Toggle between default pixel depth (4 bits-per-
pixel on most models) and 8 bits-per-pixel.
Video Gate
Sync Gate
Image Outputs
STEP R G B ACS DCS DSS ON
Cycle between monochrome, RGB and (on
models that support it) color difference video
signal types.
Video Gate
Sync Gate
Image Outputs
STEP R G B ACS DCS DSS ON
Toggle between analog and digital video signal
types.
Video Gate
Sync Gate
INSTRUCTIONS
After you have loaded the video format you
wish to use, hold down one of the two keys
indicated in the figure. Press the remain-
ing key (repeatedly if necessary) to estab-
lish the desired state.
Once the format is in the desired state,
let go of both keys. If one (or more) pri-
mary gates are inadvertently shut off by
this procedure, you can press and release
extinguished primaries, one at a time, to
turn them back on. If you get an error,
rotate the format knob to get things back
to normal.
NOTES
If the original format is not stored with a color-difference (e.g. YCrCb) type,
then the RB key combination will only switch between RGB and monochrome.
The 8-bits/pixel mode is only allowed in the digital video mode on the 801FD
and 801GD.
If the image index number displayed has only two digits, then a letter may
appear just to the left of the two digits as follows to indicate the current
state of the generator:
“ “ AVST=2 or 4;PELD=0
“C” AVST=2 or 4;PELD=8
“m” AVST=1 or 3;PELD=0
“M” AVST=1 or 3;PELD=8
“y” AVST=5,6,7,or 8;PELD=0
“Y” AVST=2 or 4;PELD=8
“ “ DVST=1,2,5,6, or 7;PELD=0
“d” DVST=10;PELD=0
“D” DVST=10;PELD=8
“b” DVST=9;PELD=0
“B” DVST=9;PELD=8
“z” DVST=13,14,15,or 16;PELD=0
“Z” DVST=13,14,15,or 16;PELD=8
Commentaires sur ces manuels